Artesyn Embedded Technology ATCA-7490, Installation And Use Manual

Page: 290 / 372

Supported IPMI Commands
ATCA-7490 Installation and Use (6806800U11F )
290
Some of the following commands refer to IPMC modes (Get Status and Reset IPMC command).
8.4.1 Get Status Command
The Get Status command can be used by the payload software to retrieve the status of the
IPMC.
Table 8-28 IPMC Modes
Mode Description
Standalone In standalone mode, the carrier IPMC disconnects from IPMB-0 but keeps on
listening to the serial debug and payload interfaces and serving requests
coming from them, as well as managing the modules, AMC point-to-point
(P2P) and clock E-keying. Standalone mode is intended for debugging
purposes and/or operation in a non-ATCA environment. In standalone mode,
the carrier IPMC automatically activates and deactivates the on-carrier
payload and modules whenever it does not violate any carrier limitations.
Manual standalone Manual standalone mode is equivalent to standalone mode with only one
exception: carrier IPMC control over the on-carrier payload is automatically
disabled in manual standalone mode.
Table 8-29 Get Status Command Description
Type Byte Data Field
Request Data 1:3 PPS IANA Private Enterprise ID
0x00400A = 16394 (Pigeon Point Systems)
LSB Byte first: byte 1 = 0A, byte 2 = 40, byte 3 = 00
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID
0x00400A = 16394 (Pigeon Point Systems)
LSB Byte first: byte 2 = 0A, byte 3 = 40, byte 4 = 00