Artesyn Embedded Technology ATCA-7370, Installation And Use Manual

Page: 208 / 252

Supported IPMI Commands
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54G )
208
Some of the following commands refer to IPMC modes which are defined as follows:
8.4.1 Get Status Command
The Get Status command can be used by the payload software to retrieve the status of the
IPMC.
Reset Carrier SDR repository Table 8-56 on page 226 0x2E/0x2F 0x33
Table 8-34 IPMC Modes
Mode Description
Standalone In standalone mode, the carrier IPMC disconnects from IPMB-0 but keeps on
listening to the serial debug and payload interfaces and serving requests
coming from them, as well as managing the modules, AMC point-to-point
(P2P) and clock E-keying. Standalone mode is intended for debugging
purposes and/or operation in a non-ATCA environment. In standalone mode,
the carrier IPMC automatically activates and deactivates the on-carrier
payload and modules whenever it does not violate any carrier limitations.
Manual standalone Manual standalone mode is equivalent to standalone mode with only one
exception: carrier IPMC control over the on-carrier payload is automatically
disabled in manual standalone mode.
Table 8-33 Pigeon Point Extension Commands (continued)
Command
NetFn
(Request/Response)
CMD
Table 8-35 Get Status Command Description
Type Byte Data Field
Request Data 1:3 PPS IANA Private Enterprise ID
0x00400A = 16394 (Pigeon Point Systems)
LSB Byte first: byte 1 = 0A, byte 2 = 40, byte 3 = 00
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID
0x00400A = 16394 (Pigeon Point Systems)
LSB Byte first: byte 2 = 0A, byte 3 = 40, byte 4 = 00