1
The Quarra PTP Ethernet Switch is configured using its webserver. The default IP address of
the Quarra is 192.168.100.100. To connect to the webserver, you change the IP address
using the Command Line Interface via RS232 (see section 1A)
OR
using the webserver via
Ethernet (see section 1B). When the Quarra’s webserver has a suitable IP address for your
network, configure the Quarra as desired (see section 2).
Quarra PTP Ethernet Switches
1A. IP CONFIGURATION VIA RS232 AND A TERMINAL
EMULATOR PROGRAM.
CONFIGURING THE QUARRA SWITCH
Connect an RS232 cable (straight not Null Modem) from your PC to the RS232 socket on the
unit. Run a terminal emulator program on your PC. The terminal emulator program will
allow you to set up the IP addresses of the webserver as desired. Older windows PCs come
with a terminal emulator program called HyperTerminal. If your PC does not have
HyperTerminal, there are some free terminal emulator programs on the Internet such as
TeraTerm and PuTTY.
Configure the terminal emulator port to:
115200 baud
8 data bits
no parity
1 stop bit
flow control - none.
Log into the console username “admin” password “”.
Username:
admin
Password:
#
Type ‘help’ or ‘?’ to get help.
To display the IP Configuration, type the following command. Only type the characters in
bold.
#
show run int vlan 1
Building configuration...
interface vlan 1
ip address 10.0.0.103 255.255.255.0
ip igmp snooping
ip igmp snooping querier election
ip igmp snooping querier address 192.0.0.1
ip igmp snooping compatibility auto
ip igmp snooping priority 0
ip igmp snooping robustness-variable 2
ip igmp snooping query-max-response-time 100
ip igmp snooping query-interval 125
ip igmp snooping last-member-query-interval 10
ip igmp snooping unsolicited-report-interval 1
!
end
#
Quarra 10G PTP Ethernet Switch
Quarra 1G PTP Ethernet Switch
Quarra 1G PTP Ethernet Switch
QUICK START GUIDE
