InfinityLink ILC450 - 10G HD/SD-SDI, ASI
IP Gateway & GigE Data Transport
•
Mon Mini BNC - In TX mode, this mini BNC outputs a copy of the ASI, SD-SDI, HD-SDI signal received
on the BNC in connector on the Rear Panel. In RX mode , this BNC outputs a copy of the ASI, SD-SDI,
HD-SDI signal sent out the BNC out on the Rear Panel.
•
RST Pushbutton - Pressing, holding in for more than 4 seconds, and then releasing this button will
reset the module interrupting data transmission through the module. Reset is similar to power-up
sequence of module. No user configuration data is changed during this reset.
ILC450 Front Panel:
1
4
3
2
1
4
3
2
5
Module Settings Configuration
1
Operational Mode
Sets Operational Mode relative to the 10G Video Circuit.
2
Video
Enable/disable video transport over the 10G link.
3
1G
Ethernet Port for 1G traffic. Options are disabled, SFP, or backplane where
available.
4
Jumbo Frames
Enables support for IP Frames that are greater than 1518 bytes and up to
9216 Bytes in size.
5
IP Address
IP address Module uses as the source address when Transmitting Video
over the 10G interface (see ILC450 manual for further details).
6
Video Alarm
Enable Alarm on loss of active video.
7
10G SFP+ Alarm
Enable Alarm on 10G SFP+ not present.
8
1G SFP Alarm
Enable Alarm on 1G SFP not present.
Receiver Settings Configuration
1
Source IP Addr
IP address that Module uses in Unicast mode to receive from.
2
Multicast Group
Multicast address that Module uses in Multicast mode to receive from.
3
Port
Port number setting must match the Port number setting on the TX module
that you wish to receive from.
4
Recovery Buffer
Specifies small or large recovery buffer size. Buffer size determines latency.
This is further determined by the Video format applied (see ILC450 manual
for further details).
Transmitter Settings Configuration
1
Video Source
Sets input port for video to “In BNC” or available backplane inputs.
2
Destination
IP Addr
Sets destination IP address to either the Multicast Group or the IP Address
of the Transmitter
3
Port
Port number setting must match the Port number setting on the RX module
that you wish to transmit to.
4
Time to Live
Sets number of route hops that a packet may make before it is dropped.
5
FEC Mode
Specifies Forward Error Correction (FEC) settings
• Specify Column or Row/Column or No FEC
• Specify matrix (row and column) size (maximum Row x Column: 3000(HD),
1500(SD), 100(ASI). (See ILC450 manual for further details.)
* Note: Confirm your network settings before connecting to your network.
Video Signal Types Configuration
1
HD-SDI
Discretely enables output of HD-SDI.
2
SD-SDI
Discretely enables output of SD-SDI.
3
ASI
Discretely enables output of ASI.
1
4
3
2
7
6
5
8
1
3
2
Artel ships the ILC450 configured as follows:
QUICK START GUIDES
