Artecta Carlow 30, Manual

Page: 10 / 24

9
Ordercode: A0720060
Carlow 30
Multiple Carlows 30 (DMX Control)
01)
Fasten the effect light to a flat surface. Leave at least 0,5 meter on all sides for air circulation.
02) Use a 3-pin XLR cable to connect the Carlows and other devices.
03)
Link the units as shown in fig. 04. Connect a light controller to the first unit's DMX "in" socket, using the
42708 – DMX input cable. Connect the first unit’s "out" socket with the second unit's "in" socket, using
the 42707 – DMX Extension cable, Link the second, third, and fourth units using the 42707 – DMX
Extension cable.
04) Supply electric power: Plug electric mains power cords into each unit's special IP65 power IN socket,
then plug the other end of the mains power cord into proper electric power supply sockets, starting
with the first unit. Do not supply power before the whole system is set up and connected properly.
Multiple Carlows 30 DMX Set Up
Fig. 04
Note : Link all cables before connecting electric power