Artecta A9915045, Manual

Page: 8 / 28

7
Ordercode: A9915045
LED Dim 12
Control Modes
Setup LED Dim 12 with Lighting Controller
01)
Use a 3-pin XLR cable to connect the LED Dims to each other.
02) Connect a lighting controller to the first device’s "in" socket.
03) Link the devices as shown in (Fig. 03). Connect a DMX signal cable from the first device's DMX/RJ45
"out" socket to the second device's "in" socket. Repeat this process to link the second, third, and
fourth devices.
04) Connect LEDs to the LED connectors on the LED Dims.
05) Supply electric power to each LED Dim, starting with the first device. Do not supply power before the
whole system is set up and connected properly.
Setup LED Dim 12 with Lighting Controller
Fig. 03
Note: Link all cables before connecting electric power