6
Ordercode: A9915045
LED Dim 12
Back
Fig. 02
04)
LED Phoenix terminal connector OUT (1–12)
●
When using RGB(W) LED strips: Connect the RGB(W) cables to the connectors with the
corresponding colors.
●
When using Cool White/Warm White LED strips: Connect the Cool White strip to the Red and Blue
connectors. Connect the Warm White strip to the Green and White connectors.
05)
3-pin DMX signal connector IN
06)
RJ45 DMX signal connector IN
07)
RJ45 DMX signal connector OUT
08)
3-pin DMX signal connector OUT
Installation
Remove all packing materials from the LED Dim 12. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Setup and Operation
Before plugging the device in, always make sure that the power supply matches the product
specification voltage.
A maximum of 6 A load is allowed on a single channel and the maximum of loads distributed over all 12
channels must not exceed 15 A.
Summary of Contents for A9915045
Page 10: ...9 Ordercode A9915045 LED Dim 12 Menu Overview...
Page 11: ...10 Ordercode A9915045 LED Dim 12...
Page 27: ...26 Ordercode A9915045 LED Dim 12...
Page 28: ...2020 Artecta...
