Artecta A9915045, Manual

Page: 24 / 28

23
Ordercode: A9915045
LED Dim 12
24 channels (WW+CW)
Channel 1 – Warm White (Output 1)
0–255
Gradual adjustment Warm White, from dark to brightest
Channel 2 – Cool White (Output 1)
0–255
Gradual adjustment Cool White, from dark to brightest
Channel 3 – Warm White (Output 2)
0–255
Gradual adjustment Warm White, from dark to brightest
Channel 4 – Cool White (Output 2)
0–255
Gradual adjustment Cool White, from dark to brightest
● ● ●
● ● ●
● ● ●
Channel 23 – Warm White (Output 12)
0–255
Gradual adjustment Warm White, from dark to brightest
Channel 24 – Cool White (Output 12)
0–255
Gradual adjustment Cool White, from dark to brightest
Maintenance
The LED Dim 12 requires almost no maintenance. However, you should keep the device clean.
Disconnect the mains power supply and then wipe the cover with a damp cloth. Do not immerse in
liquid. Do not use alcohol or solvents.
Keep connections clean. Disconnect electric power and then wipe the connections with a damp cloth.
Make sure connections are thoroughly dry before linking equipment or supplying electric power.
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by an expert after every year in the course of an acceptance test.
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by a skilled person once a year.
The following points have to be considered during the inspection:
01)
All screws used for installing the device or parts of the device have to be tightly connected and must
not be corroded.
02) There may not be any deformations on housings, fixations and installation spots.
03) Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
04) The electric power supply cables must not show any damages or material fatigue.
Troubleshooting
No Light
If the device does not operate properly, refer servicing to a technician.
Suspect four potential problem areas as: the power supply, the internal fuse, the LED Dim 12, the LEDs.
01)
Power supply. Check if the device is plugged into an appropriate power supply.
02) The internal fuse. Return the LED Dim 12 to your Artecta dealer.
03) The LED Dim 12. Return the LED Dim 12 to your Artecta dealer.
04) The LEDs. Refer to the user manual of the LEDs for more information.
05) If all appears to be O.K., plug the device in again.
06) If you are unable to determine the cause of the problem, do not open the LED Dim 12, as this may
damage the device and the warranty will become void.
07) Return the device to your Artecta dealer.