Ordercode: A0720068/A0720069/A0720070
Amaro 10W COB LED IP65
Installation
Remove all packing materials from the Amaro 10W COB LED IP65. Check if all foam and plastic padding
is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply. Use only a H05RN-F 3x1.0mm2 cable to ensure that the
device remains waterproof.
Mounting
01)
Remove the mounting bracket.
Fig. 02
02)
Put the power cable through the middle hole in the mounting bracket.
03)
If you want to secure the bracket to a wall with screws, make sure that the cable behind the bracket
is not crimped or bent too sharply, in order to avoid damage.
Fig. 03
8
