ARTDEV AS-7210 V2, User Manual

Page: 33 / 99

29
6-3 DPM, Multiple symbols, Structured append, etc. read setting
2D symbols read: A global setting of 2D symbols readability.
DPM format read: By setting Enable, the terminal can read 2D symbols in DPM (Direct Park Marking)
format. Some barcodes in DPM format are shown below.
Multiple symbols & structured append symbols read:
1) By setting Enable, the terminal allows to read multiple symbols with a single pull of the
terminal's trigger. If the user pulls and holds the trigger, aiming the terminal at a series of
symbols, it reads unique symbols once, beeping for each success read. The terminal
attempts to find and decode new symbols as long as the trigger is pulled.
2) By setting Enable, the terminal will output data only when all Structured Append symbols
have been decoded. The lower part of below figure shows an example of four Structured
Append symbols, with the same data as that in the upper symbol.
3) By setting Disable, the terminal will only read the symbol closest to the aiming beam.
Single symbol (above) and Structured Append series of symbols (below) encoding
“ ABCDEFGHIJKMNOPQRSTUVWXYZ0123456789ABCDEFGHIJKLMNOPQRSTUVWXYZ ”