6-7
FlexiBowl
®
-
models 350 - 500 - 650 - 800
CHAPTER 6 - Controls and use
6.3 Operating procedures
CAuTIon!
After carrying out the transport and installation operations, and before starting the machine, make sure
the robot vision system has been calibrated. Contact ARS S.r.l. to calibrate the vision system.
6.3.1
Preliminary inspections
Before starting the machine, the following checks need to be carried out:
• Check that the machine is placed on a surface that can withstand its weight.
• Make sure the safety devices are working properly.
• Make sure all opening guards are closed properly.
• Check that the space around the machine is free from obstacles and/or obstructions.
• Check that the machine is connected to the mains.
• Check that the power supply phases are correct.
• Check
that the surface is free to rotate.
• Check
that the Flip can run its stroke without obstruction.
• Check that the machine is not under
“Maintenance”
.
6.3.2 start-up
CAuTIon!
When the compressed air is first supplied, the Flip unit may move unexpectedly. Before turning the air on,
make sure that:
•
the power supply is fully assembled,
•
the Flip guard is in place,
•
there is nobody near the FlexiBowl
®
.
Proceed as described to
start
the machine:
step
Action
1
Turn the power switch on and supply 24 Volt.
2
Make sure the green light on the control panel is on.
If it is not, check the 230 VAC and 24 VDC power supply.
Summary of Contents for FlexiBowl 350
Page 6: ...0 6 Instructions for use and warnings TABLE OF CONTENTS PAGE INTENTIONALLY LEFT BLANK...
Page 24: ...3 6 Instructions for use and warnings CHAPTER 3 Safety measures PAGE INTENTIONALLY LEFT BLANK...
Page 82: ...9 2 Instructions for use and warnings CHAPTER 9 Attachments PAGE INTENTIONALLY LEFT BLANK...
