6
Guide Light.
Your ET200™ comes equipped with a guide light at the front of the tool
figure 1
. The light will be activated upon pressing the trigger. Your ET200™ has a safety switch at the nail exit point
figure 2
that will prevent your tool from
firing when not in contact with a work surface. To properly use your LED guide light, press trigger before tool makes contact with your work surface. After making contact with the work surface, release trigger, then press trigger
again to fire a nail.
You will find this helpful when firing nails into tighter corners and poorly lit areas.
Your ET200™ is virtually maintenance free. Keep tool clean and free of dust. Wipe clean with a dry cloth do not use harsh chemicals to clean your ET200™.
MAINTENANCE
ffiigguurree 11
ffiigguurree 22
On very hard surfaces firing recoil may
interfere with nail penetration. Enhance
driving power by firmly placing one hand
on top of cap.
ET200™ (120v)
Use #12
extension cord.
ET200220™ (220-240v)
Use Only An Earth Cable
Extension Cord
Your ET200™ contains no user serviceable parts. In the unlikely event that your ET200™ should need service contact:
Arrow Fastener Co., LLC
271 Mayhill Street, Saddle Brook, N.J. 07663
Tel. 201 843-6900