Arris NVG599, Administrator'S Handbook

Page: 116 / 228

Administrator’s Handbook
116
who
Displays the names of the current shell and PPP users.
wps
Enters the wireless WPS (Wi-Fi Protected Setup) mode.
WPS Commands
The following commands are available in WPS mode:
pushbutton
Sets the NVG599 device to WPS “pushbutton” mode, initiating protected setup.
pin
Sets the NVG599 device to PIN mode, enabling authorized devices to be identified and added by MAC address
personal identification number.
list
Lists the WPS-ready client devices (enrollees) known to the NVG599.
self-pin
Displays the NVG599’s own Personal Identification Number (PIN) value.
WAN Commands
atmping vccn [ segment | end-to-end ]
Lets you check the ATM connection reachability and network connectivity. This command sends five
Operations, Administration, and Maintenance (OAM) loopback calls to the specified VPI/VCI destination. There
is a five second total timeout interval.
Use the segment argument to ping a neighbor switch.
Use the end-to-end argument to ping a remote end node.
reset dhcp client release [ vcc-id ]
Releases the DHCP lease the NVG599 device is currently using to acquire the IP settings for the specified DSL
port. The
vcc-id identifier is an “index” letter in the range B-I, and does not directly map to the VCC in use.
Enter the reset dhcp client release command without the variable to see the letter assigned to each virtual
circuit.
reset dhcp client renew [ vcc-id ]
Renews the DHCP lease the NVG599 device is currently using to acquire the IP settings for the specified DSL
port. The
vcc-id identifier is an “index” letter in the range B-I, and does not directly map to the VCC in use.
Enter the reset dhcp client release command without the variable to see the letter assigned to each virtual
circuit.