Arris ICX 7650-48P, Configuration Manual

Page: 90 / 245

TABLE 19 ICX 7150 stacking capabilities (continued)
Stacking capability ICX 7150 Additional information
Reconfigurable ports Supported Use the no stack-port command to
reconfigure one stack port as a data uplink
port.
Once licensed, stacking ports will come up
automatically as 10-Gbps.
You can manually reconfigure 1-Gbps ports to
licensed 10-Gbps ports and vice versa using
the speed-duplex command. Refer to Ruckus
FastIron Software Licensing Guide for
information.
Stack trunks Supported Refer to ICX 7150 stacking trunks on page
96.
ICX 7150-C12P devices do not support
stacking trunks.
Linear-topology trunks ICX7150-24P: stack-trunk x/3/1 to x/3/4
ICX7150-48P: no linear-topology trunk
ICX7150-48ZP: stack-trunk x/2/1 to x/2/4
ICX7150-12C: stack-trunk x/3/1 to x/3/2 A linear-topology trunk is allowed only in a
two-unit stack. It places the ports from both
directions into one trunk.
Refer to
Support for two-unit stack linear-
topology trunks on page 36 for more
information.
Hitless switchover and hitless failover Supported Refer to Hitless stacking on page 171.
License requirements A 10-Gbps license is required to support
stacking, except on ICX 7150-48ZP devices.
Two 10-Gbps ports are standard on ICX
7150-48ZP devices, and any additional 10-
Gbps ports require a license. On other ICX
7150 models, all 10-Gbps ports require a
license.
Licenses are available for additional 10-Gbps
ports except on ICX 7150-C12P devices, which
has only two available ports. Refer to the
Ruckus FastIron Software Licensing Guide for
information.
Configuration options Manual and automatic, including interactive-
setup and zero-touch provisioning
Refer to Stack construction methods on page
56.
Access methods TFTP, SCP Software images, boot images, and signatures
can be downloaded to a stack using TFTP and
SCP. Refer to the Ruckus FastIron Software
Upgrade Guide for more information.
Stacking commands All stacking CLI is available on the ICX 7150
unless otherwise noted on the command
reference page.
ICX 7150 stacking ports
Depending on the model, up to four SFP+ ports on the front panel of the ICX 7150 device support stacking. The ports can also be
used as uplink (data) ports. The following figures show the location and numbering for stacking ports. The numbering for the
ports is in three-tuple format (x/y/z) and refers to StackID/Slot/Port.
ICX 7150-C12P devices have two stacking ports on the front panel as shown in the following figure.
Stacking by Device
ICX 7150 stack configuration overview
Ruckus FastIron Stacking Configuration Guide, 08.0.90
90 Part Number: 53-1005572-01