Arris ICX 7650-48P, Configuration Manual

Page: 77 / 245

Config changed due to add/del units. Do write mem if you want to keep it
T=1d17h53m21.5: Election, was active, no change, ID=1, pri=128, 3U(1-2,5), A=u1, nbr#=2 2, reason: u2: port-
up, ,
Config changed due to add/del units. Do write mem if you want to keep it
ICX7750-26Q Router# show stack
T=1d17h49m48.5: alone: standalone, D: dynamic cfg, S: static
ID Type Role Mac Address Pri State Comment
1 S ICX7750-26QXG active cc4e.2438.7280 128 local Ready
2 S ICX7750-26QXG member 748e.f8f9.6300 128 remote NON-OP: config mismatch
3 S ICX7750-26QXG member 0000.0000.0000 0 reserve
5 D ICX7750-48XGF member 609c.9f7f.9400 128 remote Ready, standby if reloaded
active
+---+ +---+ +---+
=2/1| 1 |2/4==2/1| 2 |2/4==2/4| 5 |2/1=
| +---+ +---+ +---+ |
| |
|-------------------------------------|
There is no standby. Will assign a standby in 50 sec
Current stack management MAC is cc4e.2438.7280
Once you have confirmed the configuration, be sure to save the configuration with the write memory command.
ICX7750-26Q Router# configure terminal
ICX7750-26Q Router(config)# write memory
Scenario 2 - Using zero-touch provisioning to configure a stack
All stack member candidates must be correctly connected.
NOTE
The zero-touch provisioning process requires clean devices, with the exception of the active controller. Clean devices do
not contain any configuration information.
NOTE
An ICX 7650 device with startup-config flash using 40-Gbps stacking ports but no other configuration is treated as a
clean unit. Because an ICX 7650 device that uses 40-Gbps stacking requires the rear-module stack-40g command
followed by the write memory and reload commands to change the default 100-Gbps stacking ports to 40-Gbps
stacking ports, the related startup-config flash must be present.
If you are adding clean units without a startup or run-time configuration to a stack, you may elect to use the stack zero-touch
provisioning process. Follow these steps to construct a stack with zero-touch provisioning.
1. Power on all candidate devices.
2. Log into the device that you want to be the active controller.
3. If necessary, on each candidate, enter the erase startup-config command in Privileged-EXEC mode, and reset the
device to convert it to a clean unit.
ICX7750-26Q Router# erase startup-config
ICX7750-26Q Router# reload-yes
Rebooting...
Building a Stack
Stack construction methods
Ruckus FastIron Stacking Configuration Guide, 08.0.90
Part Number: 53-1005572-01 77