Arris ICX 7650-48P, Configuration Manual

Page: 130 / 245

Configuring an ICX 7650 stacking trunk on a live system
Follow these steps to convert stacking ports on both ends of a link to a stacking trunk on an ICX 7650 production stack.
1. (Optional) Enter the show stack command to verify stack configuration.
ICX7650-48ZP Router# show stack
T=20h23m43.6: alone: standalone, D: dynamic cfg, S: static
ID Type Role Mac Address Pri State Comment
1 S ICX7650-48ZP active 609c.9f52.2cd5 128 local Ready
2 S ICX7650-48F standby 609c.9f52.4643 128 remote Ready
active standby
+---+ +---+
-3/3| 1 |3/1--3/1| 2 |3/3-
| +---+ +---+ |
| |
|------------------------|
Standby u2 - protocols ready, can failover or manually switch over
Role history: N: standalone, A: active, S: standby, M: member
U1: M->S->A, U2: A->S
Current stack management MAC is 609c.9f52.2cd5
Stack ports are operating at 40G.
The example shows a two-unit live stack configured in a ring with no trunks.
2. (Optional) Enter the show running-config command for additional information on the stack.
ICX7650-48ZP Router# show running-config | inc stack
stack unit 1
stack-port 1/3/1
stack-port 1/3/3
stack unit 2
stack-port 2/3/1
stack-port 2/3/3
stack enable
stack rconsole-off
stack mac 609c.9f52.2cd5
rear-module stack-40g
The example includes only stacking information in the show running-config command output. The output confirms
that the ICX 7650 stack is operating in 40-Gbps stacking mode.
3. Enter stack unit configuration mode.
ICX7650-48ZP Router# configure terminal
ICX7650-48ZP Router(config)#stack unit 1
ICX7650-48ZP Router(config-unit-1)#
Stacking by Device
ICX 7650 stack configuration overview
Ruckus FastIron Stacking Configuration Guide, 08.0.90
130 Part Number: 53-1005572-01