Arris ICX 7650-48P, Configuration Manual

Page: 103 / 245

TABLE 21 ICX 7250 stacking capability (continued)
Stacking capability ICX 7250 Additional information
Reconfigurable ports Supported Use the stack-port command to reconfigure
one stack port as a data uplink port.
Once licensed, stacking ports come up as 10-
Gbps ports automatically.
You can manually reconfigure 1-Gbps ports to
10-Gbps ports when licensed using the
speed-duplex command.
Stack trunks stack-trunk 1/2/1 to 1/2/2
stack-trunk 1/2/3 to 1/2/4
stack-trunk 1/2/5 to 1/26
stack-trunk 1/2/7 to 1/2/8 Refer to ICX 7250 trunk configuration on page
106.
Linear-topology trunks stack-trunk x/2/1 to x/2/4 or stack-trunk x/2/5
to x/2/8
Refer to Support for two-unit stack linear-
topology trunks on page 36 for more
information.
Hitless switchover and hitless failover Supported Refer to Hitless stacking on page 171.
License requirements A license is required for 10-Gbps ports.
(Trunks cannot be formed with the pre-
installed two-port license.)
The pre-installed license is for two 10-Gbps
ports (supports stacking ports 1/2/1 and
1/2/3). Licenses are available for eight 10-
Gbps ports. Refer to the Ruckus FastIron
Software Licensing Guide for information.
Configuration options Manual and automatic, including stack
interactive-setup and stack zero-touch
provisioning
Refer to Stack construction methods on page
56.
Access methods TFTP, SCP Software images, boot images, and signatures
can be downloaded to a stack using TFTP and
SCP. Refer to the Ruckus FastIron Software
Upgrade Guide for more information.
Stacking commands All stacking CLI is available on ICX 7250
devices unless otherwise noted on the
command reference page.
ICX 7250 stacking topologies
Up to 12 ICX 7250-24, ICX 7250-24P, ICX 7250-48, or ICX 7250-48P units can be connected in a linear or ring topology. Any of these
models can be mixed in the same stack. Stacking ports are located on the front panel as shown in the following figures.
NOTE
The ICX 7250-24G is not stackable.
From one to four 10-Gbps ports (from eight available 10-Gbps ports) can be used for stacking on the ICX 7250. All stacking ports
must have an active license installed to be properly configured. Active stacking ports can be configured in one of two sets of
ports on the front panel; however, stacking ports cannot be mixed between the two sets of ports because of operational
constraints. Available ports are numbered 1/2/1 through 1/2/8 as shown in the following figure.
Stacking by Device
ICX 7250 stack configuration overview
Ruckus FastIron Stacking Configuration Guide, 08.0.90
Part Number: 53-1005572-01 103