Rev D
System Management Module 2 (SMM-2)
7-31
Figure 7.27
Device Manager
Window
5. Press the
Enter
key and a login prompt will appear in the
PuTTY
terminal for logging
into the SMM-2.
6. At the login prompt, type
admin
, then press the
Enter
key.
7. At the password prompt, type
admin
, then press the
Enter
key.
To set the network information, proceed as follows:
1. After login, at the [email protected]> prompt, type
configure
and press the
Enter
key.
2. At the [email protected]% prompt, type
set interfaces
and press the
<TAB>
or
<SPACE>
followed by
?
to view all the parts of the IPv4 address command:
eth0
sets the IPv4 address
mask
sets the IP subnet mask
gateway
sets the default gateway
3. Press the
Enter
key after the all of the network information is complete
Note
The [email protected]> prompt is an example and the prompt you are likely
to see will be different.
Summary of Contents for CHP Max5000
