ARRI WVR-1, User Manual, Page: 33 / 53

Troubleshooting 33
12 Troubleshooting
Pairing
•
Make sure both transmitter and receiver are powered on.
•
Make sure the power cable is continuous.
•
Make sure that pairing units are the only wireless video
devices currently powered on.
•
Bring the transmitter and receiver closer together but no
closer than 1 meter.
•
Keep the number of solid walls between the transmitter
and receiver to a minimum.
No signal on monitor
•
Make sure the receiver is powered on.
•
Make sure the monitor is powered on.
•
Make sure the receiver is properly connected to the
monitor.
•
Make sure the monitor is set to display video from the right
source (HD-SDI1, HD-SDI2, HD-SDI3 etc.).
•
Reboot the receiver.
•
Unplug and then re-plug the HD-SDI cable between the
receiver and the monitor.
•
Replace the HD-SDI cable.
•
Make sure the video resolution is supported by the
monitor.
No video over the wireless link
•
Make sure the transmitter is properly connected to the
source.
•
Make sure the source is powered on.
•
Unplug and then re-plug the transmitter to the source.