Installation and Operation
18
8.2
Host and Client Pedal Setup
Only the right Host Pedal contains the control
electronics and thus functions as a master.
The left Client Pedal contains only an analog con-
troller that sends its values to the Host Pedal.
8.3
Analog Connection
Connect the 3-pin fishing cable (RS) to the right
Host Pedal
and then to the 3-pin Fischer socket
on the left
Client Peda
l.
8.4
LBUS Connection and Cables
CAUTION
Connecting external battery or power supply via the LBUS cable
Risk of short-circuits and back currents to power supplies/batteries.
Do not connect any external battery or power supply via the LBUS cable to the Digital Encoder
Pedals DEP-1 .
Do not insert objects.
ATTENTION
Visit the ARRI website to verify that all of the controllers you plan to use have the latest firmware.
The entire digital communication of the Digital Encoder Pedals DEP-1 is based on the LBUS.
LBUS is an ARRI/cmotion bus standard designed to allow multiple lens motors and control devices to
communicate with each other. The Digital Encoder Pedals DEP-1 is equipped with two bi-directional
LBUS interfaces providing power and control signals and daisy chain technology.
Connecting the LBUS cable
Connect the Digital Encoder Pedals DEP-1 to the remote control panel
of the stabilized remote head (SRH3 or SRH-360) using a LBUS cable
of the required length.
