ARRI ARRIFLEX 435 ES, Instruction Manual

Page: 60 / 143

Camera Operation
60
1st Display Line 2nd Display Line Adjustment Possibility
Mode 1 Total exposed film counter (m/ft) or Frame rate (fps) or Selection of a standard frame rate
take counter (m/ft) or ESU, SU in standby and Configuration of the 1st display line
mirror shutter angle of the ARRIFLEX 435ES frame rate (fps) while running on the ARRIFLEX 435ES
(external control connected)
or Pr if a program is activated
Mode 2 Programmed frame rate (PS) Programmed frame rate (fps) Programmed frame rate
ESU, SU – external control connected Current frame rate if a program (forwards / reverse)
Current shutter angle if a program is activated is activated
Mode 3 Total exposed film counter (m/ft) or Power supply voltage (V) Configuration of the film counter
take-counter (m/ft) Unit of measurement (m/ft)
Mode 4 Time Code time (hours, minutes) Time Code time (seconds, frames) Time Code on / off
Time Code time can only be set via the
CCU or externally
Mode 5 Time Code user bits Time Code user bits Time Code user bits can only be set via
Time Code warnings the CCU or externally
Mode 6 Volume of the acoustic warning signal TCS-value or Warning signal on / off
Voltage of the time code buffer battery (V) Volume
TCS-value
Mode 7 Stored program settings Frame rate (fps) 435ES: Setting of the shutter angle
435ES: set shutter angle Stored program settings
Overview of Display Modes
Mode 1 is displayed:
after switching on the camera,
after depressing the “RUN”-button or
30 seconds after the last operation.
Mode 4 and 5 can only be selected
if the functional expansion module is attached.