ARRI ARRIFLEX 235, Instruction Manual

Page: 61 / 178

61 61
Setting a Programmed Frame Rate
(Mode 2)
Standby Operation
• Change from Mode 1 to Mode 2 by depressing the
“MODE”-button once.
• Depress the “SEL”-button repeatedly until the digit to
be set blinks.
• Depress the “SET”-button repeatedly until the desired
value is reached.
• Repeat this procedure until all digits are set to the
desired values. A final confirmation of the set frame
rate is not necessary.
Note: The frame rate can be set between 1 and 60 fps
forward and 25 fps reverse.
Note: The programmed frame rate is stored in a non-
volatile memory.
Switching Between Forward and Reverse Operation (Mode 2)
Standby Operation
• Change from Mode 1 to Mode 2 by depressing the
“MODE”-button once.
• Depress the “SEL”-button; “Cd” (Camera direction) blinks.
• Hold the “SET”-button depressed for more than three
seconds. The display shows an “R” for reverse
operation at the bottom left.
Changing the Frame Rate while the Camera is Running
By means of the “NORM” and “PS/CCU”-buttons it is
possible to switch between the standard frame rate
(“NORM”) and the pro-grammed frame rate (“PS/CCU”)
while the camera is running.
Camera Operation