19
19
4.5 Lens Support
The lens support consists of the lens support LS-7 (can be
snapped onto 19 mm support rods)
➪
photo
or the lens
support LS-8 (can be pushed onto 15 mm support rods) and
the respective lens support ring
➪
photo
for the lens in use.
• Mount the lens support onto the support rods from above
and let it click into place by applying slight pressure
(push the LS-8 onto the support rods from the front).
• Slide the relevant support ring
➪
photo
onto the lens
but do not tighten.
• Then slide the lens into the lens mount receptacle and lock.
• Connect the support ring to the lens support and tighten
the knurled screw
➪
photo
as well as the clamping
lever
➪
photo
.
• Complete the process by tightening the clamp screw
➪
photo
on the support ring.
Note:
Mounting the support ring on the relevant lens
is usually carried out only once. The support
ring can then remain in position on the lens.
base plate
lens support
LS-8
lens support ring
clamp screw
wedge plate
knurled screw
lens support
LS-7
clamping lever
Installation
Summary of Contents for ARRIFLEX 235
