TOP-PAD-IP2 DESKTOP INTERCOM STATION
User Manual
page 32/64
armtel.com
© Armtel
In “Setting” panel you can select the interface language (Russian and English keys,
change the screen color, set the required volume for speakers of the panel and handset as
well as the microphones sensitivity and screen brightness via virtual sliders.
«Volume» key
is used for rapid volume increasing of the integrated speakers
and the handset speaker during call with a subscriber.
«No microphone» key
enables to turn off the microphone (handset microphone)
without disturbing of the voice traffic. To turn on the microphones, you should touch «No
microphone» key again.
2.5.3 Assigning virtual keys to the working field of the panel
Function keys (FK) are the virtual keys of the working field programmed to perform
the communication function or local functions. TOP-PAD-IP2 keys function are configured
from the Administrator personal computer using IPN Config Tool. The basic options for
providing connection setup, maintenance and disconnection between subscribers are
duplex settings (available values: «OFF», «Manual»
и
«Full»,
и
«Priority level». The specified
priority within the range from the minimum (0) up to the maximum (255) is assigned to each
function including the local function “Clear”. The priority may be assigned not only to each
direction of the call individually (indicated on the direct key) but also to the total of all
outgoing connections («default priority» value is in the settings for each unit provided). All
connections are located in the integral field of priorities, regardless of the following criteria:
−
«Armtel-IP» or SIP communication protocols;
−
communication functions, for example, «Direct call of a subscriber» or «Direct
call of a group»;
−
direction of communication: incoming and outgoing connections.
With several incoming calls occurring simultaneously, the priorities are compared, and
the connection with the highest priority is selected.
When assigning functions to the keys, an auxiliary operating mode “Committing” can
be established, in this mode, it is sufficient to touch a function key to perform
the programmed function. If this mode has not been established, the User should constantly
touch the key to perform the function.
A local function is a function that does not depend on the type of either SIP or
«Armtel-IP» signaling protocols and such as «Latter connection», «Increase volume»,
«Reduce volume» etc. You can use the local functions during communication with
subscribers.
