6
Estimated Assembly Time: 25 minutes
Tools Required for Assembly: Drill, Screwdriver
Helpful Tools: Level
WARNING:
DO NOT PLUG IN POWER CORD TO POWER OUTLET, MAKE SURE PLUG IS
DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Undo the latches. (fig.2)
3. Lift the power head off the container. (fig.3)
4. Remove the contents from inside the container, make sure you have all contents as listed on page 5.
(fig.4)
5. Your vacuum comes ready for dry vacuum cleaning with the supplied reusable cloth filter installed. (fig.5)
6. For wet vacuum cleaning, install the supplied foam filter. (fig.6) See page 10 for filter installation.
7. Replace the power head back on the container. (fig.7)
8. Aligning the top section with the latches, and snap into place. (fig.8)
9. Insert the hose into the vacuum port. (fig.9)
10. Choose the desired nozzle and insert onto the end of the hose. (fig.10)
For your convenience this vacuum comes with a wall mounting support for storage.
IMPORTANT!
Do not mount the rack over 5 feet from the floor.
GENERAL ASSEMBLY INSTRUCTIONS
