Arkray AUTION ELEVEN AE-4022, Operating Manual

Page: 142 / 161

4.2 Replacing the thermal recording paper
AE-4022
4-13
3 Prepare a new roll of thermal recording paper
a
Cut the first (outermost) layer of a new thermal recording paper
roll, and trim the end to make it straight. A skewed or odd-shaped
end may cause the thermal recording paper to jam.
4 Set the new thermal recording paper roll
a
Place the new roll of thermal recording paper in the paper holder,
orienting it correctly so that the paper feeds from the bottom.
Guide the trimmed end of the thermal recording paper into and
through the slot that receives the recording paper.
The thermal recording paper is automatically wound forward and
fed into the unit.
NOTE:
When the thermal recording paper is completely removed
from the printer, the screen message shown in the right
figure appears and a continuous beep sounds for
approximately 1 minute. The alarm sound can be stopped
by pressing
.
Paper holder
Set the new roll of thermal
recording paper in the
paper holder in the proper
orientation so that the end
feeds from the bottom.
NOTE:
Always press the button after replacing the thermal
recording paper.If you do not fully feed the thermal
recording paper through the unit by pressing the button,
the printer will fail to print the measurement results.
REFERENCE:
If the printer fails to properly wind and feed the thermal recording paper, press and verify that the paper feeds
correctly.