background image

SM229-SRVC & CM929-SRVC       Swivel Vent Universal Mobile Phone or PDA Mount

 

Consumer Hotline: 
(USA)    (800) 841-0884
(INT'L)   (626) 254-9005
               Mon-Fri. 9am-5pm, PST

www.arkon.com

Arcadia, CA 91006 USA

Made in Taiwan

© Copyright 2007 Arkon Resources, Inc.

The Mobile Mounting Specialists

TM

CM047-S (Single T-tab)

CM047-S2 (Dual T-tab)

CM047-S (Single T-tab)

CM047-S2 (Dual T-tab)

CM090

CM090-2

SM020

SM020-2

CM929-SRVC

Flat side face up

Step 1.

Step 2.

Adjust the swivel angle of the pedestal head by f

ir

mly holding 

the back of the pedestal (B), pulling out the pedestal head and 
twisting to the desired angle. Adjust the lateral angle of the 
pedestal head (E) by simply twis

t

ing the head on the pivot axis 

(D). 

Use caution when adjusting the swivel movement to avoid 
damaging your air vents.

Attach the device cradle to the pedestal by inserting the dual T-
Tabs of the pedestal (E) into the T-slots of the cradle (F).

Step 3. Carefully slide the pedestal from the vent/blade. Make sure the 

teeth of the vent clips are open enough so as not to damage the 
vent. 

Pedestal Adjustment & Device Cradle Installation

Step 1.

Step 2.

Remove the device from the vent 
mount assembly.

Pinch the vent clips (A) so that the 
teeth open.

Pedestal Removal

Step 1.

Attach the vent mounting clips (A) to the back of the pedestal (B) 
with the vent clips positioned with the flat sides facing up. 

Pedestal Assembly

Step 1.

Pinch the vent mounting clips (A) so that the teeth open and 
gently insert vent pedestal into vent louvres until the mounting 
clips are attached to the fin/blade of the vent. Adjust the support 
leg (C) vertically until it rests firmly along the bottom of the vent 
or dash surface below the vent. 

Insertion of Pedestal into the Air Vent

(A)

(C)

 

 

SM229-SRVC

(F)

(E)

(D)

(B)

(A)

(A)

(B)

 

(J)

(K)

(I)

 

Step 1.

Step 2.

Step 3.

Universal Cradle Instructions

If necessary, adjust the support legs (K) by sliding them 
laterally. These provide support for your device.

Place device on the support legs (K) and squeeze the side 
grip arms (I) until they fit securely to the device.

Push the release button (J) in order to release the device from 
the cradle.  

Safety Precautions

Do not install Arkon products over an air bag cover or within the air 
bag deployment zone. Arkon Resources, Inc. assumes no responsi-
bility of liability for injury or death as a result of car crashes and/or 
air bag deployment.

Arkon Resources, Inc. is not responsible for any damages caused to 
your air vent louvres, car, device or yourself as a result of the instal-
lation or use of this mount.

Reviews: