MAINTENANCE
23
0
0
1
.0
8
8
7
5
r
e
v
.
1
0
4. Gently, remove the rear cab from the
Voyager. Just lift enough the frame from the
front cab to unplug the 2 control switch
connectors from the circuit board. Remove
the frame from the front cab.
5. Unplug the red/white and the black/white
wires from the board.
6. Unplug the blue and white wires plug.
7. Unplug the two wires (brown and blue)
attached to the motor.
8. Unscrew the “no 20 Tork screw”. To remove
the electric board.
9. Screw the new electric board back in place
and plug the unplugged wire to it. Plug the
brown wire in the red motor plug and the
blue and purple wire together.
10. Gently put the frame in the front cab just
enough to plug back the 2 control button
connectors with the white dot mark facing
the Quick Release (back) side. Place the
carry handle in the front cab. Place the rear
cab and screw a few thread of all 6 screws
front the rear cab. Tighten the
Quick
Release
button.
11. Flip the voyager and unscrew a few threads
of all the 4 screws from the front cab. Install
the strap guide and screw it. Align the cab
and tight the 4 carry handle screws. Tighten
the 2 center screws from the rear cab.
12. Flip the Voyager to the front. Screw the
2 screws at the bottom of the cab. Make
