6. Dismantling the Bed
1
Remove the mattress and all accessories installed on the bed, such as
side rails, lifting pole, etc.
Use the control handset to lower the bed to minimum height with the
mattress platform horizontal. Lower the backrest and leg sections to their
flat positions.
Disconnect the bed from the electricity supply.
Apply the brakes on all four castors.
Attach plastic ties to secure the movable backrest and leg sections to the
bed frame.
Turn the bed onto its left side (as viewed from the head end).
2
Push a flat-bladed screwdriver into the slot on the side of the control box
to release the clip holding the cover.
Slide the cover off the control box.
3
Unplug the control handset from the control box and put it to one side.
Unplug the foot end actuator cable (green) from the control box.
Unplug the leg section actuator cable (yellow) from the control box.
Do not unplug the backrest (red), head end (white) or battery cables from
the control box.
Slide the cover back onto the control box until it “clicks” into place.
4
Pull off the plastic cap from the head end actuator socket and disconnect
the cable from the actuator. Replace the cap.
Repeat this procedure for the foot end actuator.
5
Use a 5mm hex (Allen) key to remove the two socket head fixing screws
securing the foot end panel section to the bed.
Pull the foot end panel section away from the bed and lay it on the floor.
6
Remove the two socket head fixing screws securing the foot end
mattress platform section to the bed.
Pull the foot end mattress platform section away from the bed, taking
care not to trap or pinch the actuator cables, and lay it on the floor.
746-574-AM-1
48
