Folding steel side rails
These instructions show the fitting of side rails model CM-ACC06.52.
Extra height folding side rails CM-ACC07.52 are attached and used in
the same way. Extra height side rails should be used when the
mattress thickness is between 5.9in.(15cm) and 6.8in.(17.2cm). Refer
to page 12.
The folding side rails are supplied as a pair to suit the right and left hand sides
of the bed, as viewed from the head end. These illustrations show the left-hand
side rail.
Installation
Position the side rail assembly on the
side frame of the bed, with the two
fixing brackets hooked over the top of
the bed frame.
The spacer bar (A) must be located
behind the edge of the head end
panel as shown; this will ensure the
side rail is correctly positioned on the
bed.
Position the side rail initially with it tilted towards the middle of the
bed. When both brackets are correctly located on the bed frame,
rotate the complete side rail assembly back to the vertical.
A
746-574-AM-1
31
