Aritech 1X-E4 Series, Installation Manual

Page: 13 / 100

Chapter 2: Installation
1X-E4 Series Installation Manual 7
Menu inserts
The last step in installing the cabinet is to apply the menu insert that corresponds
to the intended system configuration.
The default configuration does not use EN 54-13 zone supervision. For this
configuration, use the printed insert identified as NEN 2575.
If the panel will be configured to use EN 54-13 zone supervision, the
corresponding insert includes a label for the Fault Output Fault/Disabled LED.
Use the printed insert identified as NEN 2575 - EN 54-13.
To apply the menu inserts:
1. Add the detection zone names and evacuation area names to the top insert
segment.
Detection zone names go in the left column. Evacuation area names go in the
right column, above the preprinted LED label text.
2. Detach the four insert segments from the sheet.
3. Remove the control panel cover.
4. Insert each segment in the appropriate slot, as shown in Figure 3 below.
Make sure that the inserts are positioned correctly.
5. Replace the control panel cover.
Figure 3: Applying the menu inserts