Aritech 1 3E Series, Installation Manual

Page: 41 / 114

Chapter 3: Configuration and commissioning
1X-X3E Series Installation Manual 35
Panel mode
Use this read-only menu to view the operating mode of the control panel.
To view the panel mode:
1. Set the display as shown below, and then press Enter.
Display indications for each operating mode are shown below.
Display Panel mode Description
Basic standard Fire sounders cannot be manually activated (fire
sounders are only activated if there is a fire alarm).
Basic evacuation Fire sounders can be manually activated at operator
user level (a fire alarm is not required).
BS 7273 mode stage 1 Fire sounders cannot be silenced automatically after
the panel changes from pre-activated to activated
state. They cannot be silenced automatically after the
panel changes from ‘Activated’ to ‘Released’ state.
BS 7273 mode stage 2 Fire sounders cannot be silenced automatically after
the panel changes from pre-activated to activated
state. They cannot be silenced automatically after the
panel changes from ‘Activated’ to ‘Released’ state.
Repeater with fire routing
(EN 54-2)
Fire routing functionality can be repeated.
Repeater with fire routing
(BS 7273)
Fire routing functionality can be repeated.
Custom A custom operating mode is configured. The display
alternates between CU (custom) and the operation
mode.
Note: In basic evacuation operating mode, the configured actuator delay is
bypassed when MCP Start is activated. The actuator output is activated
immediately.
Custom panel operating mode
A custom panel operating mode will be indicated if any of the following zone
configuration settings are changed from the operating mode preset values:
• Zone delay
• Zone configuration
• Zone type