Arista CloudVision DCA-100-CV, Quick Start Manual

Page: 36 / 46

fixNw Fixes CVA network config to what is expected
Does not touch devicebr config.
-vm,--vm Used for CVA VM emulation - NOT for HW CVA
-f, --force Do what I say. Used for bypassing yes/no
question for reboot.
6. Use the
# version
command to verify that the upgrade was successful.
Multi-node configurations
A rolling upgrade should be done when upgrading multi-node CV Appliance configurations. The steps you use
are exactly the same as the steps used for single-node configurations, except that you must repeat the procedure
for each node.
The basic steps involved in performing the rolling upgrade are:
• Login to one of the CV Appliance hosts.
• Complete the upgrade using the steps in the procedure. (Make sure you follow the rules in the Important!
notice below when performing the upgrade.)
• Wait until all CVX and CVP VMs are up and running before you begin the upgrade on the next host.
Note: Important! To complete the rolling upgrade, you must:
• Upgrade only one CV Appliance host (machine) at a time.
• Wait after each host machine is upgraded, until all CVX VMs and CVP VMs are fully up and
running before you begin the upgrade on the next host in the cluster.
CVP takes approximately 20 minutes to be fully accessible after the system reboot (running the
upgrade
script, which is done near the end of the procedure, automatically reboots the system).
Verify that CVP is accessible before you begin to upgrade the next CV Appliance host in your
multi-node cluster configuration.
Complete the following steps to upgrade multi-node CV Appliance configurations.
1. Go to https://www.arista.com .
2. Download the mfg tgz tools (
arista-cv-<version>-mfg.tgz
).
3. Extract tar -xvf arista-cv-<version>-mfg.tgz . This ensures you have the new version of
upgradeCva.py.
4. Download the update ISO.
5. Run the upgrade CV Appliance tool.
upgradeCva.py -i <Arista Cva Update Iso>
$ ./upgradeCva.py -h
usage: upgradeCva.py [-h] [-i ISO] [--fixNw] [--useLacp] [--reboot] [-f]
[-r]
Upgrade base image
optional arguments:
-h, --help show this help message and exit
-i ISO, --iso ISO Path to ISO
fixNw Fixes CVA network config to what is expected
Does not touch devicebr config.
-vm,--vm Used for CVA VM emulation - NOT for HW CVA
-f, --force Do what I say. Used for bypassing yes/no
question for reboot.
DCA-100-CV Quick Start Guide
32