Arista CloudVision DCA-100-CV, Quick Start Manual

Page: 21 / 46

Chapter
4
Setting Up CV Applications
Setting Up CVP
Note: Single-Node is not recommended for production deployments.
Pre-installation checklist
• Ensure that you have console access to the CVP virtual machine on each appliance, via WOK web access.
• Enter the CVP Console.
• Ensure all configurations are done via console and not via SSH.
Note: This configuration will change the IPs and will drop connectivity if done over SSH.
Setup Steps for Single Node CVP
1.
Access primary CVP VM via WOK. See Web Access into CVX and CVP Consoles via WOK .
2.
Refer to the CloudVision Configuration Guide for Shell-Based Configuration of a Single-Node.
Setup Steps for Multi-node CVP Cluster
Assign to each of the three CVP VMs a role (primary, secondary or tertiary).
• The roles may be assigned in any way, but the roles must be kept consistent throughout the installation. No
two nodes may share the same role.
• Maintain the installation order starting with primary, then secondary and finally tertiary.
1.
Access the primary, secondary and tertiary CVP VMs on the respective appliance via WOK. See Web Access
into CVX and CVP Consoles via WOK .
2.
Refer to the CloudVision Configuration Guide for Shell-Based Configuration of Multi-Node.
Log into the CVP Web Interface
After CVP is running on the multi-node appliance cluster, enter the CVP Web Interface of the primary node via
its CVP IP/Hostname with default username/password of
cvpadmin/cvpadmin
to set the password.
17