Step One:
Unfold Handlebar
1.
Remove the lower and loosen the upper hardware on the
handlebar assembly.
2.
Loosen the hardware on the shift rod.
3.
Put the speed selector lever in the sixth forward position.
4.
Rotate the handlebar into operating position.
NOTE:
Be careful not to damage cable spring hooks when rotating
handlebar upward.
5.
Install and tighten the hardware on the handlebar assembly.
6.
Tighten the hardware on the shift rod. Make sure that the rod
is correctly seated before tightening.
7.
Check tension on auger and traction clutch cables.
IMPORTANT:
Cables should not be slack nor under tension. Adjust
as necessary.
