EN – 11
BOTTOM COVER REMOVAL
IMPORTANT:
Save all hardware for reinstallation.
1.
Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2.
Disconnect spark plug wire from engine.
3.
Place unit in service position. See
4.
Remove hardware retaining bottom cover to frame
and remove cover. See Figure 14.
IMPORTANT:
For track models, track angle must be in the
“Raised Position” to remove bottom cover. Refer to
Operator’s Manual. See Figure 15.
Install Bottom Cover
1.
Secure bottom cover to frame with six hex screws.
2.
Return unit to operating position.
3.
Reconnect spark plug wire and fill fuel tank.
WARNING:
AVOID INJURY. Before placing unit
in service position, drain fuel from tank and fuel
system. See
Make sure unit is secure and will not tip.
Figure 14
Figure 15