Ariens 911086, Owner'S/Operator'S Manual, Page: 8 / 22

GB - 9
Replace worn-out mufflers immediately.
Continued use could result in fire or explosion.
Sharp edges can cut or amputate fingers or a
hand. Wrap blade or wear sturdy gloves to
service.
Use only replacement parts designed for your
unit. See your Ariens Dealer.
Allow engine to cool before storing in any
enclosure.
ALWAYS clean unit before extended storage.
See engine manual for proper storage.
DO NOT store unit inside a building with fuel in
the fuel tank where any ignition sources are
present.
Use only accessories which have been
approved by Ariens and are properly installed.
Check attachments frequently and replace
worn or damaged components with
manufacturer’s recommended parts.
CARTON CONTENTS
ASSEMBLY
1. Unfold and adjust handlebar. See Service
and Adjustments.
2. Self-Propelled Models: The speed control
rod is shipped on the handlebar with
hardware in position. Remove hair pin,
insert bent end of rod through hole in
swivel of speed control bell crank, and
retain with hair pin (Figure 5).
3. Fill engine crankcase with oil. See engine
manual.
4. Assemble grass bag onto bag frame.
5. Set-up mower for bagging, side
discharge or mulching. See Mower Set-
Up in Operation Section.
6. Fill fuel tank. See Operation Section.
7. Check the engine/blade control feature.
Try starting the engine without the
engine/blade control held against the
handlebar. Engine must not start. If
engine starts, stop engine and adjust or
repair engine/blade control. See Service
and Adjustments.
ASSEMBLY
CAUTION: AAVOID INJURY. Read
and understand the entire Safety
section before proceeding.
Figure 4
1. Mower Unit
2. Side Discharge Deflector
3. Grass Bag
4. Grass Bag Frame
5. Literature Pack
OM0350
2
3
1
4
5
OM1222
OM0330
OM0320
OM0340