Page 2-28
0040501006 3814
Operating and installation instructions
Thrust actuator ARI-PREMIO
®
-Plus 2G
5.5 Settings - Handling
5.5.1 Display and operating elements of the standard electronics
Fig. 15
ATTENTION !
- The thrust actuator may only be operated for a short time without the hood for
unavoidable setting operations to the electronics, the relay board and the electrical
options. While these operations are in progress, the thrust actuator has hazardous,
live, uninsulated parts exposed as well as moving and rotating parts.
- Improper execution of the setting operations or lack of care may cause death,
grievous bodily injury or substantial property damage.
- Operation of the thrust actuator without the hood for any purpose other than that
described above is strictly prohibited.
LEDs for status information
Rpm / operating speed adjustment
RPM = rounds per minute
Local operation of the actuator
- Up, stop, down
- Auto: The actuator follows the control
signals
Led`s blinking for travel in open /
close direction and
lit continuously in
end position
Reset button or start / cancel
initialization run
Configuration of the analogue control
signal
- Current / voltage
- Inversion
- Failsafe
behaviour
in
case
of
control
signal
failure
Actuator functions
- Force off (tight closing function)
- Anti-block retraction program
- Economy - wear reduction program
