20 Operation on a POTS access
278
ARGUS 152
20 Operation on a POTS access
The voltages on the subscriber line may not exceed 130 VDC and should be free
of AC voltage.
20.1 Setting the POTS Interface
Use the included connection cable to connect the ARGUS (Line jack) to the POTS access
to be tested and then switch the ARGUS on. The POTS settings are made in the chapter 5
Configuring accesses page 23. In this example the POTS TE mode was selected:
Note:
Open the Main Menu and select "Help" or press number key "1". An overview of the
possible key combinations can be found on page 100.
The various menus available for the
selected type of access will be shown in
the Main Menu.
The ARGUS will open the
marked menu (in this example,
Single tests).
Select a menu. The selected
menu will be marked blue in the
display.
Return to the previous menu (in
the example, the State display).
The ARGUS displays the voltage on the
line when it is "on hook“ (not busy).
Positive voltage: Polarity on a+; on b-
(red wire is a, black wire is b)
Negative voltage: Polarity on a-; on b+
<Setting>
Opens the Settings menu for
POTS parameters, see page
279.
<Menu>
Open the Main Menu
<Call>
For information on setting up a
call, see page 281.
ARGUS State Display
Main Menu
