7 Operation on a VDSL Access
ARGUS 145
PLUS
79
Settings:
Explanation:
Access parameters
Phys. parameters:
VDSL
Access parameters for the VDSL connection
Rated value
Use the keypad to enter the upstream and downstream comparison
values for the bitrate [kbit/s]. If the current bitrates on the VDSL
connection exceed the rated values, the ARGUS will display "OK“,
otherwise it will display "FAIL“.
Default setting:
d: 0
and
u: 0
FW
Selection of the firmware (FW) in the VDSL chipset.
The following options are available - FS9 and FS10.
Default setting:
FS10
Protocol:
Selection of the transfer protocol that the ARGUS should use for the
test (e.g. for an IP test).
Protocols for VDSL:
PPPoE (PPPoEoA) - Point-to-Point Protocol over Ethernet
IP (IPoE) - Internet Protocol over Ethernet
Default setting:
PPPoE
MAC / VLAN:
MAC (Media Access Control) and VLAN (Virtual Local Area Network)
MAC address
Display and selection of the MAC addresses.
The first two MAC addresses cannot be changed.
If the default MAC address is selected, the Argus will use its own MAC
address.
Default setting:
Standard MAC address
If Dynamic MAC Address is select a different MAC address will be used
for each synchronization.
A third MAC address can be entered:
Mark a line and then press <Edit>.
<Edit>
Open the MAC address for entry.
Enter the address in hexadecimal from the keypad and
the softkeys
<A..F>
(e.g. to enter a “C” press the
softkey three times or to enter an “F” six times, then
finish up by pressing
<OK>
to confirm your entry).
Default setting:
00:00:00:00:00:00
