Argo All 6X6, Service Manual

Page: 95 / 297

Brake System Argo Service Manual
BR-7
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
3. Rotate the caliper up and past the ROPS mounting bracket to access and remove the
hex head bolts securing the pads in the caliper.
4. Slip out the brake pads from the caliper.
Installing The Service Brake Pads
CAUTION
Ensure the brake pads are NOT installed backwards. The pad side must be installed
towards the brake disc. The brake pads utilize a black coloured anti-squeal coating
on the opposite side of the pad which could be mistaken for the pad surface.
1. Before installing the new pads, gently pry the pistons back into the calliper first to al -
low clearance for the new pads. Slip the new pads into the calliper and reinstall bolts
after applying Blue 242 LOCTITE to the threads. Torque to 25 FT.LBS. 20.3Nm
2. Attach the calliper and bracket back to the vehicle main frame using two (2) C/BOLT
3/8-16X1.0 GR5 ZN, WASHER .39X.94X.13 ZN D i -C hro and Locknut N ylon
3/8-16 ZP.
IMPORTANT
Loosely snug the nuts to the brake bracket. Apply the hand brake a few times to set
the brake bracket position, then apply the brake and hold while tightly securing the
nuts. Torque to 31 FT.LBS
Service Brake Bedding In Procedure
Bedding in of the service brakes is recommended by the brake pad manufacturer to
obtain maximum performance and wear from the brake pads. When new service brake
pads have been installed, the following procedure will need to be completed. Please
include this procedure immediately after service pads have been replaced.
1. Ensure that the service brake system has been bled to provide maximum braking.
2. For this procedure select an area that is open and flat, such as an empty parking lot.
BR INDEX MAIN INDEX