Subject to change · 33143400 · 05.2016 · EN
Page 19
www.argo-hytos.com
10.3. Replacing the filter element
1. Pump the filter element dry - (see Chapter 9.2 "Filtering liquids in the bypass flow" Point 7)
2. Turn the filter unit on at the on/off switch (circuit breaker) and pull the mains plug.
10.3.1 Removing the filter element
Fig. 5: Removing the filter element
1. Turn the housing cover (1) counterclockwise.
2. Carefully remove the cover (1) with the filter element (2) from the filter tube.
(The filter element is attached to the cover.
Let the draining oil drip off into the housing.)
Fig. 6: Removing the filter element from the cover
10.3.2 Removing the filter element from the cover
1. Push the filter element at the cover in arrow direction 1 and remove it in
arrow direction 2.
2. Dispose of the filter element according to the national environmental
legislation (Waste code: Oil filter 16 01 07).
Fig. 7: Attaching the filter element
10.3.3 Attaching the filter element
1. Check the filter element type number.
Does the load inscription on the filter element match with the indications on
the typeplate or in the operating manual?
2. Attach the filter element in arrow direction 2 and lock it in arrow direction 1.
10.3.4 Installing the filter element
1. Always replace the O-ring in the cover, when changing the filter element
(part of the scope of delivery of the filter element)
(O-ring Order No. N007.1175, included in spare filter elements).
2. Carefully insert the cover (1) with the filter element (2) into the filter tube.
3. Screw in the cover manually until it stops.
A gap between cover and filter pipe may remain visible
(see Chapter 8.1 "Before commissioning" / Fig. 3)
Fig. 8: Installing the filter element
CAUTION
Risk of burns
Contact temperatures according to DIN EN563 (3) and DIN EN13202 (4) may be exceeded
during operation.
Allow the filter unit to cool down before touching it.
