I N S TA L L AT I O N T I P S
CARE + MAINTENANCE
Avoid acetone silicones upon installation, harsh chemicals and abrasive
cloths when cleaning (as these will scratch the chrome surface), waxed
based furniture creams (as these can result in a build up of deposits and may
detract from the appearance). Clean using a soft soapy cloth and polish with
a dry soft cloth and do not use undue pressure whilst cleaning. Ensure all
new installations are fully flushed prior to installing the ceramic headparts to
prevent any possible damage to the product and voiding of the warranty.
LICENCED PLUMBER / INSTALLER
This water saving range of tapware and outlets have been fitted with flow
restrictors which can create greater hydrostatic back pressure to the ceramic
cartridge.
Always flush water inlet lines on new installations before fitting tapware to
avoid damage to ceramic valve.
Please Note:
- These tapware sets contain ceramic disc 180° turn spindles.
- Product not installed by a licensed plumber or in accordance with
relevant industry standards and regulations may void the manufacturers
warranty terms & conditions.
Please ensure the operating pressure to all points in the building conforms to
AS/NZS 3500.1 and does not exceed 500KPA .
Failure to limit the operating flow pressure, may void the warranty on this
fixture.
PR TEMPERATURE REQUIREMENTS
Ensure operating water pressure is between 1-5 bar
(100-500Kpa).
If pressure is in excess of 500Kpa fit pressure reduction valve to ensure
installation conforms to AS/NZ 3500.1
This tapware set is not recommended for use with low pressure gravity feed
water systems.
Maximum hot water temperature 80°C.
WARRANTY
All Argent products are covered by a three (3) year warranty from the date
of purchase. Argent will undertake to rectify free of charge for parts and
labour, within this period any fault due to defects in materials or workmanship.
Regardless of interim service within that period, the warranty shall expire after
three (3) years from the date of original purchase.
Finishes
All Argent finishes are warranted against chipping and flaking, excluding
normal wear and tear for three (3) years from date of purchase.
Headparts
All Argent replacement headparts will only be covered by warranty if the
fault can be clearly shown to have existed as a result of defect in manufac-
ture. There is a twelve (12) month warranty period only applicable for these
replacement parts.
Exclusions
This warranty is for normal domestic and commercial use only and excludes
any defect or injury caused by or resulting from misuse, abuse or neglect, ac-
cidental damage, improper installation or installation by unlicensed plumber,
products not installed to relevant National Standards and State Regulations.
Z e n B a s i n S e t
I N S TA L L AT I O N I N S T R U C T I O N S
WELS 5 star rated
Nominal flow rate 5Lpm
AS 3718
WMKA21008
SAI GLOBAL
107509
Zen S Basin Set
107409
Zen Basin Set
Brisbane
Level 3 / 18 Wandoo Street
Fortitude Valley QLD 4006
Sydney
80 Abercrombie Street
Chippendale NSW 2008
Melbourne
198 Coventry Street
South Melbourne VIC 3205
Perth
Unit 1 / 40 Collingwood Street
Osborne Park WA 6017
Technical Advice
1800 356 717
Fax
1300 656 057
www.argentaust.com.au
The more
stars the more
water efficient
A joint government and industry program
Licence No. 0008
When tested in accordance with Standard AS/NZS 6400
For more information and to compare
products, refer to:
www.waterrating.gov.au
5
Water Consumption
litres per minute
WATER
RATING
ARG-001-254
, InsIns Zen Ba
sinSet
Aus
tr
alian
D
esign
R
egis
tr
ati
on
AUS
T. DES. REGN. NO. 307310
AUS
T. DES. REGN. NO. 30
73
11
AUS
T. DES. REGN. NO.
307312
