Areva MiCOM P225, Technical Manual

Page: 119 / 288

Menu of the HMI P225/EN HI/B11
MiCOM P225 Page 9/48
2.5 The INPUT CONFIG. submenu
CONFIGURATION
Press the
!
and
"
keys to enter into the
CONFIGURATION menu.
INPUT CONFIG.
To move about in the INPUT CONFIG. menu, press the
! and " keys. To go to the CONFIG. SELECT, CT/VT
RATIO, LED 5, LED 6, LED 7, LED 8 and ALARM
CONFIG. submenus, press the
% and $ keys.
INPUT 6 5 4 3 2 1
PICK-UP 1 1 1 1 1 1
To configurate the active/inactive state of each binary
input, press the
#
key, use the
!
and
"
keys,
Then confirm your choice pressing the # key.
0 : inactive state when a control voltage is applied on.
1 : active state when a control voltage is applied on.
CONTROL VOLT =
DC
Configuration of the control voltage type necessary to
power on the binary inputs.
Choice :
DC : Direct current voltage Vdc
AC : Alternative current voltage Vac
Warning ! This choice is only possible on some versions
of the product.