background image

LED INGROUND

User's manual

Walk­over 230V ac LED inground

This  instruction  manual  contains  important 
information  about  the  installation  and  use  of  the 
projector.  Please  read  and  follow  these 
instructions carefully.
The  security  of  this  device  is  guaranteed  only 
with  the  proper  use  of  the  following  instructions, 
therefore they must be kept carefully.
Never  install  the  device  in  locations  easily 
accessible by people who ignore the existence of 
this user's manual and safety instructions.
Disconnect the unit from any power supply before 
attempting  any  operation  in  contact  or  inside  the 
unit, and when not in use.
Prior  to  connect  the  unit  to  the  power  supply, 
check  the  output  voltage  fits  the  technical 
requirements on the label.
Never  let  the  power  cord  come  into  contact  with 
other cables.
Never touch the electrical contacts, either directly 
with your fingers, or indirectly by means of sharp 
or metal objects.
Make sure that cables cannot cause trip hazard.
Do not attempt to dismantle and modify the unit.
Due  to  the  high  technological  level  of  this  unit, 
any service maintenance should be performed by 
specialised operators. Please contact your Arena 
Luci dealer for any operation.
Always ensure that the structure to which you are 
attaching the unit is secure and is able to support 
the weight of each unit.

Avoid installing the unit close to heat sources.
Never lean the power cord on hot unit surfaces.
Allowed  to  be  mounted  directly  on  inflammable 
surfaces.
Do  not  install  the  luminaire  on  deformed  or 
damaged surfaces.
The lighting apparatus must be used only with its 
protective shield.
Contact  your  Arena  Luci  dealer  if  the  protective 
shield is visibly damaged to the point at which its 
effectiveness  is  diminished,  for  example  by 
becoming cracked or deeply scratched.
LED module is not replaceable.
Do  not  use  any  solvent  based  cleaning  agents. 
Use only a soft, dry anti­static cloth.
The installation of LED modules (including power 
supplies)  should  be  done  according  to  current 
technical  rules  and  regulations.  The  installation 
should be performed only by a qualified operator.
This luminaire is an outdoor IP67 device, but not 
IP68  (underwater).  Therefore  the  proper  and 
extended functioning will be related to the proper 
installation.
To  avoid  infiltrations  inside  the  inground  box  do 
not  open  or  install  this  luminaire  during  rainy 
days or in high humidity conditions.
Avoid  contact  with  either  corrosive  agents  or 
humidity  and  moisture  on  delicate  elements: 
damages  from  corrosion  are  not  refunded  as 
component defects.

WARNINGS

Please  note  that  as  part  of  Arena  Luci's  ongoing  commitment  to  continuous  product  development, 

specifications  are  subject  to  change  in  the  course  of  product  improvement  without  notice. Arena  Luci  is  not 

responsible for damages resulting from improper or different use than expected.

FL0040

FL0042

Summary of Contents for LED INGROUND

Page 1: ...void installing the unit close to heat sources Never lean the power cord on hot unit surfaces Allowed to be mounted directly on inflammable surfaces Do not install the luminaire on deformed or damaged surfaces The lighting apparatus must be used only with its protective shield Contact your Arena Luci dealer if the protective shield is visibly damaged to the point at which its effectiveness is dimi...

Page 2: ...installation is complete the unit is at the same level of ground surface or floor A the inground box must be placed on a layer of draining pebbles with a minimum thickness of 30cm in order to make easier the flow of rain water and avoid the lift of moisture inside the box B the bottom layer of the installation should be ma de with a material with proper draining capability C the shunt from the 230...

Page 3: ...e figure respecting the right polarity L N E labelled on the wiring terminals colours L brown N blue E yellow green It is essential that each projector is correctly earthed and that electrical installation conforms to all the standards of good practice and safety regulations The absorption of a single device is 10W at full capacity The FL0040 FL0042 models cannot be powered by dimming control devi...

Page 4: ...nings Disposal of Old Electrical Electronic Equipment applicable in the European Union and other European countries with separate collection systems The product shall not be treated as household waste but must be handed over to the applicable collection point for the recycling of electrical and electronic equipment By ensuring this product is correctly disposed you will help prevent potential nega...

Reviews: