HARDWARE INSTALLATION
13
2.4 Installation
Your enclosure supports up to 8 3.5-inch disk drives or 2.5-inch
SAS or SATA 12.0Gb/s drives, each one contained in its individual
drive carrier. Each drive is hot-pluggable, allowing you to remove
and insert drives without shutting down your enclosure.
Following the instruction below to install ARC-4038 compact tower
JBOD enclosure.
Step 1. Installing SAS/SATA Drives in the ARC-4038 JBOD
Enclosure
Follow the steps below to install the 3.5-inch drives or 2.5-inch
drives into the drive tray.
a. Install the drives into the drive tray and make sure the holes of
the disk trays align with the holes of the drive.
Figure 2-2, Put 2.5-inch
SAS/SATA drive into disk
tray
Figure 2-3, Put 3.5-inch
SAS/SATA drive into disk
tray
b. Turn the drive tray upside down and using a screwdriver to se-
cure the drive to the drive tray by four of the mounting screws.
Figure 2-4, Installing 2.5-inch
SAS/SATA Drive
Figure 2-5, Installing 3.5-inch
SAS/SATA Drive
