Original User Manual
–
A
REBO
S Convector 2300W
11
Information about the device
•
The convector AR-HE-KV2300W / AR-HE-KV2300B is used to generate warm air for indoor use.
•
The device generates heat via an electric heating element. The air around the heating element
is heated. The heated air rises upwards through the air outlet, creating a natural suction that
allows cold room air to draw into the device.
•
In addition, the device has a fan that allows faster distribution of the heated air.
•
The device has an integrated temperature sensor that regulates the heating depending on the
current and desired room temperature.
•
You can set a target temperature value between 5 °C and 37 °C via the control panel integrated
in the housing.
•
The device also has a remote control that can be used to control all functions and settings.
•
The integrated timer makes it possible to switch off the device with a time delay.
•
The two devices are identical in function, they differ only in colour: The device AR-HE-
KV2300W is white and the device AR-HE-KV2300B is black.
3
Installation and commissioning
WARNING!
Make sure you are sufficiently distanced from walls, fixtures or other equipment. The
distance must be at least 1 m from the front and side walls of the appliance in order to eliminate the
risk of fire.
Unpack the device
•
Remove the device and all accessories from the package. Check that the device has no signs of
damage.
•
Completely remove the packaging from the device.
•
Unwind the power cord completely. Make sure that the power cord is not damaged and do
not damage it when unwinding.
•
Choose a fixed, flat and non-combustible location.
•
Plug the power plug into a suitable 220 - 240V~50/60Hz outlet and make sure the power
button is set to "OFF".
Assembly
WARNING!
risk of injury due to incorrect installation due to electrical voltage! There may be
local or national regulations for assembly. We recommend that you have the assembly carried out by
an electrician.
WARNING!
Fire hazard due to incorrect installation! There is a risk of fire if the required
minimum distances are not observed. Pay full attention to the content in the chapter Assembly and
commissioning as well as the technical data in the chapter Technical data.
Mounting feet
WARNING!
Make sure that the 2 feet are mounted before using the heater to ensure a sufficient
distance to the stand surface.
•
Remove the device and all accessories from the packaging and check that the device shows no
signs of damage.
•
Turn the main unit over (short side) place it on a table or the packaging box and mount the
two feet with the four screws ST4 * 16.
