Owner’s Notes for
Ardent
March 26
th
, 2021
25
If the engine continues to run, shut the fuel shutoff valve on top of the fuel tank and
starve the engine of fuel.
•
The fuel cutoff valve is a small valve that can be accessed from the port stern
berth under the bedding and a sliding horizontal panel -- labeled.
•
The engine will not stop immediately when the fuel is valve is shut. It will take
some time to starve the engine of fuel.
After engine stops, turn off the Power Switch on the engine panel to deenergize the
electronics.
Notify SJS immediately anytime an emergency shutdown is performed.
16.
Entertainment System
Ardent is equipped with a FUSION marine
entertainment system for audio.
•
AM/FM radio
•
Wired and wireless (Bluetooth) connections
for audio players (iPod, iPad, Smart Phones)
•
Speakers are in the salon and aft end of the
cockpit.
•
The audio system can be controlled from:
a)
The B&G Zeus
T7 display located in the salon, port side above
the VHF base unit.
b)
the B&G Zeus
T12 display located on the aft end of the
cockpit table.
c)
The FUSION wired remote controller (in the cabinet above
the electrical panel, starboard side of the salon).
Getting Started
The system is best controlled using the B&G displays in the salon or cockpit.
Following are the steps to get you going playing your favorite tunes:
a)
Flip ON the NAV/INSTR switch on the electrical panel.
b)
Using the T7 or T12 display, press the yellow bar at the bottom. See photo top right.
c)
A new bar will appear just above. See photo top right. Press the MENU icon near the right side of the
bar.
d)
A dialog box will appear on the left, select your source – AM/FM Radio or connect to device. Press the
right side of SOURCE on the dialog box to get a list of sources.
Connecting to a Device using a USB cable
a)
Connect your device’s USB cord to the “iPod” outlet on the USB outlet box located in the cabinet above
the electrical panel. See photo above right.
b)
Select “iPod” from the source dialog box on the T7/T12 display.
Connecting to a Device using the WiFI-1 Onboard Network – refer to the WiFi procedure at the end of
Section 13 above.
