arcus-eds
I
KNX
SYS
IP
KNX System Devices
Application Description
Gateway KNX-GW-IP-2TE
Arcus-EDS GmbH
Rigaer Str. 88 , 10247 Berlin
Tel.: +49 / (0)30 / 2593 3914
Fax.: +49 / (0)30 / 2593 3915
e2
Subject to change
Page 14
Example for a simple HTML visualization
General information
To use groupmonitoring and telegramlogging your browser must support websockets. If this is not the case, a notification will be
displayed on the respective pages.
In certain instances, such as the device being shut down right after a change in configuration, a loss of configuration files may
occur. In that case the red RESET-LED will blink periodically during rebooting. To reset the device hold down the RST-key during
booting until the RESET-LED turns off and then back on again. Please note that it is recommended to wait 10 seconds after a
change in configuration before shutting the device down. Save your configurations to restore them loss-free.
To mount a µSD-card insert the card with the mount-switch turned off. Then switch it on. If a µSD-card fails to mount, turn the
switch to ´unmount´ again, remove the card, and repeat the steps.
Seite 14
