Arctic Power eSled CSC 2015, Operator'S Manual

Page: 58 / 116

Liite 2 (5)
5
The eSled snowmobile
How to start
1. Attach the tether (2) and raise the kill
switch (x).
2. Make sure that the power pack master
switch (x) is turned on.
3. Turn the key (1) to crank until you see
”Changing mode” on the screen.
4. The eSled is in drive mode after you
hear a beep and the drive led (3) is lit.
How to power off the drive mode
Never power the snowmobile off by
turning the power pack master switch
(x) to off.
To power off the snowmobile completely
turn the key (1) to position off
To power off the drive mode cycle tether
(2) or kill switch (x).
How to charge the snowmobile
1. Power off the drive mode.
2. Attach the tether and raise the kill
switch. Make sure that the power pack
master switch is turned on.
3. Connect the other end of the charger
cable to the wall socket or the charger
station.
4. Turn the key to position ”ON”. Do not
crank.
5. Connect the charger connector to the
charger socket in front of the
handlebar.
6. Wait until the charger goes to floating
state and the charge procedure is
completed.
7. Disconnect the charger connector.
8. Power must be cycled by the tether, kill
switch or the key before able to turn on
the drive mode.